Skip to main content
All CollectionsUsing tado°How to use your tado° devices
What do the symbols on the Wired Smart Thermostat X or Wireless Temperature Sensor X mean?
What do the symbols on the Wired Smart Thermostat X or Wireless Temperature Sensor X mean?

Find out what the icons in your device’s user interface mean.

tado° avatar
Written by tado°
Updated over a week ago

Control Buttons

You can turn on the LED-powered display of the Wired Smart Thermostat X or Wireless Temperature Sensor X by pressing any of the three buttons on the front of the device.

You can manually increase or decrease the temperature by pressing the up and down arrow buttons.

You can switch between viewing the measured temperature and the target temperature by pressing the middle button. The middle button also allows you to restart the device if you press and hold it for ten seconds.

The display has an automated timeout by default and will turn off after a few seconds.

Temperature Values

The temperature on the display represents the measured room temperature if accompanied by a thermometer icon. Otherwise, the temperature represents the target temperature.

The following icons relate to the temperature values shown on the display.

Icon

Meaning

Thermometer

Appears next to the current measured temperature.

Off

The heating is off and set to frost protection (5°C).

Heat Request

0, 1, 2, or 3 wavy lines indicate the amount of heat being requested.

Target Temperature Modes

The following icons may appear next to the target temperature. They give more information about how the target temperature was set or how it is being optimised.

Icon

Meaning

Schedule

The device is following a Smart Schedule.

Manual

The device is following a command set manually on the device or via the tado° app.

Away

Your tado Home is in Away mode and the device is following the preset Away mode setting.

Energy-saving feature active

Either Open Window Detection or Balance is adjusting your usual schedule to reduce unnecessary heating. You can resume your usual schedule at any time in the app.

Connection Status

The following icons give information about the device’s connection status. These icons appear during the installation process or if the device experiences a connectivity issue.

Icon

Meaning

Device is discoverable

The device can now be connected to any Matter-enabled device through the app.

Connecting

The device is in the process of connecting to your Matter network.

Connection failed

The device was unable to connect. Refer to this article for troubleshooting.

Successfully connected

The device has been connected. This icon will disappear after a few seconds.

Signal lost

The device has lost connection with the Thread border router.

Refer to this article for troubleshooting.

General

Below are the other symbols you might see in your Wired Smart Thermostat X or Wireless Temperature Sensor X display.

Icon

Meaning

Depleted Battery

Change the battery as soon as possible.

For more information about changing the batteries, refer to this article.

Did this answer your question?