The Wired Smart Thermostat X (2nd gen) and Wireless Temperature Sensor X (2nd gen) have a rechargeable lithium battery that can be charged with a standard USB-C cable. The charger should be rated for 5VDC and 0.5A minimum. You can charge your device at any time, but we recommend fully charging the battery before installing your device and before each heating season.
Follow these steps to charge your Wired Smart Thermostat X (2nd gen) or Wireless Temperature Sensor X (2nd gen):
Plug a standard USB-C charger cable into the USB-C port on the device. You can charge the device while mounted on the wall or after unmounting it.
Connect the device to power. A charging battery symbol will appear on the device’s interface when plugged in. The same symbol will appear if you try to wake the device up by pressing the button while it’s charging.
When the battery is fully charged (which could take 4-5 hours), the charging battery symbol won’t be shown anymore, and you can unplug the USB-C cable. Whenever you are unplugging the device, you can check the battery state. If the device is fully charged, a full battery symbol will appear.
Will my heating still work while the battery is charging?
Yes. The Wired Smart Thermostat X (2nd gen) and Wireless Temperature Sensor X (2nd gen) will keep working normally while charging. However, if you remove your Wired Smart Thermostat X (2nd gen) from its wallplate, it stops controlling the heating and switches it off automatically.
How often do I need to charge my Wired Smart Thermostat X (2nd gen) or Wireless Temperature Sensor X (2nd gen)?
The Wired Smart Thermostat X (2nd gen) or Wireless Temperature Sensor X (2nd gen) battery lasts up to one year. We recommend charging the battery before the heating season begins. You can buy a USB-C cable in our webshop.
Please note:
Only use the indicated battery type. to avoid damaging your device.
Batteries in disconnected devices deplete much faster than in connected devices. To maximise battery life, keep your devices connected and set your rooms to OFF when no heat is needed, such as in summer.
How long does it take to charge my Wired Smart Thermostat X (2nd gen) or Wireless Temperature Sensor X (2nd gen)?
It takes approximately 4-5 hours to fully charge your Wired Smart Thermostat X (2nd gen) or Wireless Temperature Sensor X (2nd gen).
Can I replace the battery of my Wired Smart Thermostat X (2nd gen) or Wireless Temperature Sensor X (2nd gen)?
Yes. If you want to replace the battery of your Wired Smart Thermostat X (2nd gen) or Wireless Temperature Sensor X (2nd gen), please follow the instructions below carefully.
Important:
Only use the recommended battery type* to avoid risk of explosion.
Make sure the battery is not crushed, cut, or punctured.
Safely dispose of old batteries at a designated recycling location.
How do I remove the old battery?
1. Unmount the device from the wall. | 2. Unscrew the back using a Torx 6 screwdriver. | 3. Open the device. | 4. Unplug the battery (which may require a gentle but firm pull) by grasping the connector, not the cables. | 5. Carefully remove the battery by gently detaching it from the adhesive.
Note: Do not use any sharp objects to avoid damaging the battery or the device. |
|
|
|
|
|
How do I insert the new battery?
1. Place the new battery and secure it with double-sided adhesive tape. | 2. Plug the new battery in by grasping the connector, not the cables. | 3. Close the device. | 4. Screw the back gently using a Torx 6 screwdriver. | 5. Mount the device to the wall. |
|
|
|
|
|
* You can obtain the battery from your preferred supplier using the following battery type details: GSP103030-1000mAh 3.7V.