If you have tado° V3+ devices, please read this article for proper assistance.
tado° Stand
If you can’t or don’t want to fix your Wireless Temperature Sensor X (2nd gen) or Wireless Temperature Sensor X (1st gen) to the wall, you can use the tado° Stand to position your device on a table or other surface in the room.
This will allow for greater flexibility in positioning your devices to enhance their functionality.
Fitting your device onto the Stand
Wireless Temperature Sensor X (2nd gen)
To fit the Wireless Temperature Sensor X (2nd gen) to the Stand, please do the following:
Remove the backplate of the device.
Position the backplate on the Stand so that the top screw holes on both pieces are aligned.
Use the screws provided with the Stand to fix the backplate to the Stand as shown.
Clip the device back onto the backplate.
Wireless Temperature Sensor X (1st gen)
To fit the Wireless Temperature Sensor X (1st gen) to the Stand, please do the following:
Remove the backplate of the device.
Remove the terminal cover above the battery compartment.
Position the backplate on the Stand so that the top screw holes on both pieces are aligned.
Use the screws provided with the Stand to fix the backplate to the Stand as shown.
Clip the device back onto the backplate.
tado° Trim Plate
If you want a quick, clean installation without plastering or paintwork, you can use the tado° Trim Plate to position your device.
Because of the screw spacing, we recommend using the Trim Plate with the Wired Smart Thermostat X (2nd gen) and the Wired Smart Thermostat X (1st gen).
Fitting your device on the Trim Plate
To fit the Wired Smart Thermostat X (2nd gen) or Wired Smart Thermostat X (1st gen) on the Trim Plate, please do the following:
Carefully remove the piece bridging the two holes with a safety knife to enlarge the opening, and dispose of the removed piece.
Position the Trim Plate over the cable outlet and use a pencil to mark the drill hole positions.
Drill two 6mm holes at the marked positions for the wall plugs.
Push the wall plugs into the existing drilled holes until they are flush with the wall.
Position the Trim Plate over the wall box with the arrows on the back pointing down. Align it with the wall plugs. Then attach the backplate of the device to the Trim Plate using the rounded screws. Then mount the device until it clicks securely.
Wired Smart Thermostat X (2nd gen)